Skip to content
Nozzle & Vernier
‹ All work

Drone motor stator and hub

A laminated stator and hub assembly for a drone-motor maker's R&D: measured from a motor on the market, then reworked for their own design.

DesignSolidWorksReverse engineeringGoing to prototype

Render of the laminated stator assembled on its blue hub, with the top bearing showing in the centre
The job
A drone-motor maker wanted to build its own motor, starting from one already on the market. They needed the laminated stator, its insulation and the hub it mounts on as clean CAD they could prototype from and keep changing.
What I did
Measured the market motor's laminated stator and modelled it, then drew a second version reworked for their design. Modelled the insulation end plates for both, designed the hub that carries the stator on two bearings, and made drawings for each part.
How it turned out
The assembly is ready for prototyping. It is not in production yet.
Software
SolidWorks
Parts
Laminated stator, insulation plates, hub, two bearings
Laminated stator
28 mm across, 12 slots
Stage
Design done, prototype next
Describe the part you need

More of this job

Render: the assembly coming apart into hub, laminated stator and two bearings, then closing up again
Exploded render: top bearing, laminated stator, hub and bottom bearing on one axis
Exploded render: top bearing, laminated stator, hub and bottom bearing on one axis
Render of the laminated stator with its insulation end plates lifted off top and bottom
Render of the laminated stator with its insulation end plates lifted off top and bottom
Top view of both laminated stators: the one measured from the market motor and the reworked version
Top view of both laminated stators: the one measured from the market motor and the reworked version