Skip to content
Nozzle & Vernier
‹ All work

Perfboard soldering jig

A two-colour printed jig that holds every part of a small sensor board in place, so the board can be flipped and soldered in one go.

Design + printTwo-colour printSoldering jigElectronics

The jig from the side, showing the red top layer and the white body, behind the finished board
The job
A small sensor board for a drone motor test setup had to be hand-soldered on perfboard. With parts of different heights, they fall out or tilt the moment the board is turned over to solder.
What I did
Laid the components out on the perfboard grid from the wiring diagram, then modelled a block with a pocket for each part at its own depth. Printed it in two colours: a red top layer that shows where each part goes, and a name drawn on the underside.
How it turned out
Parts drop into the jig, the board goes on top and the whole stack flips over. Every joint was soldered in one sitting with nothing moving.
Printer
Bambu Lab X2D with AMS
Colours
Red top layer, white body
Use
Holding parts while soldering a perfboard
Describe the part you need

More of this job

The board laid on the jig: the red face sits flat on the perfboard over every component, then the stack flips to the solder side
Wiring diagram of the board: where each component and wire link sits on the perfboard grid
Wiring diagram of the board: where each component and wire link sits on the perfboard grid
The board held over the jig with the components pushed into their pockets
The board held over the jig with the components pushed into their pockets
The solder side of the board, all joints done while the jig held the parts
The solder side of the board, all joints done while the jig held the parts
The board lifted off the jig after soldering
The board lifted off the jig after soldering
The finished board from above
The finished board from above
The underside of the jig with a hand-drawn name and smiley printed in red
The underside of the jig with a hand-drawn name and smiley printed in red
Second sheet of the wiring diagram: the wire links on the solder side
Second sheet of the wiring diagram: the wire links on the solder side